SSC4 Satellite Channel Controller

The SCC4 can be driven in two ways:

Option 1:  If you only select 2 channels on each "SIDE"

Download the "preset" channel values once and control it 
via relay closures.  See SCC4 docs on downloading notes.
Once downloaded, shorting the following contacts will 
select between the A1/A2, and B1/B2 settings:
	Shorting 1 and 2 selects the A1 PRESET
	Shorting 2 and 3 selects the A2 PRESET
	Shorting 4 and 5 selects the B1 PRESET
	Shorting 5 and 6 selects the B2 PRESET

Thus if you hook up these pairs to 4 relays on the 
USN1616, you can switch by PULSING the appropriate relay 
in the Playlist.

Option 2:  For UNLIMITED channel selects on each side.

Redownload it with CartReady's COMTALK command every time 
you wish to send channels. When using Option 2, you 
HARD-WIRE the SCC4 to one PRESET on each side.  EX:

If you hard-wire A1, you run a jumper between 1 and 2.
If you hard-wire B1, you run a jumper between 4 and 5.

Thus since A1 corresponds to "1" in the download, and B1 
corresponds to "3", you'd send the following sequences in 
the COMTALK command...   You MUST hard-wire the presets 
since you don't want the SCC4 to accidentally flip to the 
A2 if you are always driving the A1 etc.

1) Remember, COMTALK should be set to the COM port you 
physically connected the SCC4 to on your computer.

2) Protocol is always  2400,N,8,1.  If you hit enter on
SCC4 controller under HARDWARE, it will do this 
automatically.

3) The string you send is:  --[PRESET][SAT CHANNEL]q
	where -- signifies two spaces,
  	where [PRESET] is either 1 or 3 in our example
	where [SAT CHANNEL] is the channel you want
	where q is q  (i.e always end with a q)

Thus   --110q   would make the A1 PRESET be channel 10
	since you've hard-wired A1 always on, your A side
	of the sat card would be on 10.  (-- is two spaces!)

WIREREADY NSI  (800) 833-4459 (508) 879-0080 FAX 879-1199

			TECHDOCS\INSTALL\SCC4.INS