WEGENER RECEIVER


MODEL#:  DR-96

PHYSICAL DESCRIPTION:

1) There are 6 LEDS on the front of the receiver.

2)  There are 10 DIPS on the back of the receiver.   The position of the first 8 does not matter.  
In order for WireReady to work properly, 9 should be DOWN and 10 should be UP.

3)  The receiver puts out data on a RS-232 9-pin port labeled CTRL.

4)  Pin-Outs:

    WEGENER                 COMPUTER
  ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
   9-PIN      TO       9-PIN or  25-PIN
  ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
    2                    2         3
    5                    5         7
    4                    4         20
    7                    7         4


5)  Reset messages can be sent by NETWORK INDIANA ONLY.

6)  Configuration should be 9600 N,8,1.




Presently if you are receiving the Network Indiana service on a parallel printer than you must 
already have the Intersat Receiver.  Coming out of the Intersat Receiver is a Parallel Cable  
that runs directly to your printer.   In order to have Serial Output to a computer you will need 
another device.  This device is an RJ11 jack with a phone-line that will come from the back of 
the receiver Service: Port #1 (there is 4 output ports it MUST be in Port 1) and it will connect 
to a converter which is part of the same device which will then have a serial cable which ends 
in a 9pin Female plug which will plug into your computers Com1 serial port.  If you do not 
have this device you must contact Scott Eucker at Network Indiana.    His Phone Number is 
317-575-5750.